1. micro bearing temperature overheating solutions

Miniature bearings heat for different reasons, so the solutions in different ways, here is a miniature bearing temperature of solution:

(1) method of filling grease

So-called filling grease method is to fill in the appropriate amount of grease to the bearing surface on a regular basis, is one of the most commonly used way of lubricating grease.

(2) oil Cup

Oil Cup is set on the bearing-cap oil or oil pressure oil Cup, regularly rotate the CAP gun grease or oil injection. This is a common way of lubricating grease.

(3) pressure grease method

For grease method relies on the grease pump for grease pressure. Liquid grease should be used at this time.

(4) method of centralized grease

Centralized grease method grease pump, while the deep groove ball bearings and other parts for fat. Similarly, his flow of grease should be used at this time and good resistance to oxidation and corrosion resistance of grease and a pressure grease method.

2. micro bearing heating considerations

(1) place the yoke iron on the end surface of the host.

(2) Insert the plug into the power socket on the control switch.

(3) check that the ground wire is good, use pencil test after power on.

(4) press the Start button, the host power.

(5) check the yoke iron should be no voltage to ground.

(6) press Stop button to host power stops heating.

(7) according to different specifications of miniature bearings or other artifacts, choose a different yoke sleeve, this put the yoke iron on the top surface of the host, should fit flat.

(8) when heated miniature bearings, the sensor should be inserted "sensing socket" and close to the heated sensor artifacts.